Dial-up spojeni

[Zbynek Houska]

Ahoj,

  vim, ze otazka je polozena velice obecne, a omlouvam se za to.
Proste jsem jinak nemohl...Samozrejme jsem prostudoval Handbook jako
prvni a po nejake dobe laborovani jsem se odhodlal pozadat o pomoc.

Toto jsou hlasky ktere jsem dostal podle tveho postupu:

Script started on Sun Aug  3 21:58:15 2003
root at skippy# ppp papchap
Working in interactive mode
Using interface: tun1
ppp ON skippy> set log local +TCP/IP +CBCP +CCP +Chat +Connect +IPCP
+LCP +Phase
ppp ON skippy> dial
Phase: bundle: Establish
Phase: deflink: closed -> opening
Phase: deflink: Connected!
Phase: deflink: opening -> dial
Chat: deflink: Dial attempt 1 of 1
ppp ON skippy> Chat: Send: AT
Chat: Expect(5): OK
Chat: Received: AT
Chat: Received: OK
Chat: Send: ATE1Q0
Chat: Expect(5): OK
Chat: Received: ATE1Q0
Chat: Received: OK
Chat: Send: ATDT
Chat: Expect(40): CONNECT
Chat: Received: ATDT
Chat: Received: BUSY
Warning: Chat script failed
Phase: deflink: dial -> hangup
Phase: deflink: Disconnected!
Phase: deflink: Connect time: 6 secs: 0 octets in, 0 octets out
Phase: deflink: 0 packets in, 0 packets out
Phase:  total 0 bytes/sec, peak 0 bytes/sec on Sun Aug  3 21:59:40
2003
Phase: deflink: hangup -> closed
Phase: bundle: Dead
ppp ON skippy> q
root at skippy# exit
exit

Script done on Sun Aug  3 22:00:11 2003

Sam jsem spojeni navazoval trochu jinak, ale mam tu samou chybu "chat
script failed".
Takze kde by mohl byt problem? Pouzivam 4.8 RELEASE.


Zbynek

______________________________________________________________________
Reklama:
"auto-plus". Ověřená kvalita ojetých vozů. Nejrychlejší a nejsnazší systém hledání. http://ad2.seznam.cz/redir.cgi?instance=53643%26url=http://www.auto-plus.cz