Jak nabootovat BSD, inst. nad 1023 cylindr

[Cejka Rudolf]

Keklak Peter 01 wrote (2001/04/26):
> potrebuji rozchodit FreeBSD instalovany nad 1023-ti cylindr, tj na konec 20
> ti gigoveho disku. Nemam zadne zkusenosti, jak to udelat, aby me bootoval
> system. Pokud je to v helpu, tak si to prectu, ale mam za to, ze tam nic
> nepisou, jen upozornuji, ze to nepojede, nebo tak neco. Muzete me nekdo
> malinko poradit ? Dekuji predem

Jednu chvili to slo v -currentu i defaultne, ale postavilo se proti
tomu dost lidi, protoze od te doby nemohli nabootovat. Pro instalaci
boot0 slouzi boot0cfg a v man boot0cfg pisou i o bootovani nad 1023:

     -o options
             A comma-separated string of any of the following options may be
             specified (with ``no'' prepended as necessary):

             packet  Use the disk packet (BIOS Int 0x13 extensions) interface,
                     as as opposed to the legacy (CHS) interface, when doing
                     disk I/O.  This allows booting above cylinder 1023, but
                     requires specific BIOS support.  The default is
                     `nopacket'.
     ...

Takze ja bych zkusil pouzit neco jako
"boot0cfg -B -v -f boot.save -o packet -s 1 -t 36 ad0".

-- 
Rudolf Cejka   (cejkar at dcse.fee.vutbr.cz;  http://www.fee.vutbr.cz/~cejkar)
Brno University of Technology, Faculty of El. Engineering and Comp. Science
Bozetechova 2, 612 66  Brno, Czech Republic