Neco malo k AIC7895, pomuze to?

Cejka Rudolf xcejka00 at dcse.fee.vutbr.cz
Tue Jun 16 10:55:04 CEST 1998


Tohle dneska proslo dotazy:
Pomuze to tomu cloveku, co se ptal na 7895?

> Date: Mon, 15 Jun 1998 21:54:15 -0700 (PDT)
> From: Doug White <dwhite at gdi.uoregon.edu>
> Subject: Re: adaptec 78xx & 3c905TX <- Installing onto.
> 
> On Fri, 12 Jun 1998, Graham Bignell wrote:
> 
> > 	I want to install FreeBSD on a system (detailed below) that has
> > an on-board adaptec 7800 family SCSI controller as well as a 3com 3C905TX NIC,
> > I understand the 2.2.6 distribution does not support either but that I might have
> > luck with one of the 3.0 snapshots.   Could you place me on the path to an
> > install floppy that would work?  Can I build 3.0 over ftp?
> 
> This isn't enough information.  There are probably 20 chips in the Adaptec
> AIC78?? family.  Anything below 789x should be fine; the 7895 requires
> CAM.
> 
> If the 3com card is the 905B you're sunk, but the straight 905 works fine.
> 
> > Asus P2B-LS board with onboard Adaptec 2940U controller (on boot I see
> > 	a message about the 7890 BIOS.)
> 
> Hm, Asus's page doesn't list a P2B-LS, there's an L and an S but no LS. 
> The P2B-S says it's a 7890, which requires CAM.  
> 
> A CAM boot floppy and instructions should be here:
> http://www.freebsd.org/~abial/cam-boot/
> 
> Doug White                              | University of Oregon  
> Internet:  dwhite at resnet.uoregon.edu    | Residence Networking Assistant
> http://gladstone.uoregon.edu/~dwhite    | Computer Science Major
> NOTICE:  Make sure your mailer replies to dwhite at resnet or I won't get it! 

Ale jak se zda, tak jen 3.0. To pak zalezi na tom, k cemu je dany
system urcen...

--------------------------------------------------------------------------
Rudolf Cejka                            E-mail: xcejka00 at dcse.fee.vutbr.cz
Technical University of Brno, Faculty of El. Engineering and Comp. Science
Bozetechova 2, 612 66 Brno, Czech Republic



More information about the Users-l mailing list